Pandemic

This was a Pan Speed Customer Car.

Shaken is possible

1994 though so a bit old and it has higher klms. 117,000
But everything has been rebuilt and replaced about 10000klms ago.

It is very close to what I wanted to begin with.
It needs some TLC and a lot of rusty bolts replaced.

Body looks good. All Pan Speed Circa 2007 and some other items. Rear Fenders are cut and welded.
T04Z with HKS FConv tune, Cross Cut close ratio mission and Twin Plate clutch

It has been sitting outside some of it's life I'd imagine.
Vented bonnet not helping keep water out.
It is a bit rusty in areas around the battery mount.
Steel engine pulleys are also a little rusty.
Bolts on the wing are rusty
Exposed steel areas of the roll cage are a little rusty too.
Although Ohlins look perfect. super clean.

No Shaken, so I couldn't drive it, But idling and rev seemed good. No Smoke.

I'm probably crazy to even consider this... haha.

But

There is about 4.5M worth of tuning on this car.

I put some rough numbers beside items.

RX7 TUNING

FD3s 1994
Tuning Pan Speed

Engine Original apex seal 10000Klm Rebuild 
Fuel pump NISMO in Tank
Rotor 8.5
Turbine To4Z O / H after 10000Km 
manifold
Wastegate External

CPU F Con V Pro Ver3.24
Intercooler Three-layer
Radiator Three-layer copper core
Exhaust System Pan Speed
Straight Pipe and Muffler
Air cleaner HKS

Suspension F& R Ohlins Pan Speed Spec
Wheels 17-inch Regamaster Evo
Tire Size F&R 265/40-17  Direzza
Mission OS Giken Cross
Clutch Twin OS Giken 
Flywheel OS Giken
Stock LSD

Roll bar Pan Speed 5-point

Blitz DSBC
Blitz Boost gauge,
Blitz water temperature gauge

BRIDE BRIX Seat
Seatbelt Sabelt
Steering MOMO
Knob Aluminium
Audio deck Carrozzeria CD, MD

Pan Speed GT2000 Front
Pan Speed Wide Fender
Pan Speed Vertical Fin
Pan Speed Side step
Mazdaspeed Rear Under Skirt GT-C
Pan Speed Rear fender  
Pan Speed Hood FRp GT2000
Wing SARD 3d

Enhanced PPF

What to do???? 480ps....! Lets go racing!

Hmmmm.